README FILE FOR INSTALLATION AND OPERATION OF ACCELEROMETER-BASED GLOVE CONTROLLER

BEFORE RUNNING THE PROGRAM:

1. Connect the black ground wire to the ground pin of the DIO1 Header
2. Connect the Red power wire to the 3.3V signal pin of the DIO1 Header
3. Connect the Vertical Axis wire (White) to the Onboard ADC Channel 2 (10 Pin ADC Header)
4. Connect the Horizontal Axis wire (Yellow) to the Onboard ADC Channel 4 (10 Pin ADC Header)

EXECUTING THE PROGRAM

1. Type in the command to execute the compiled C file in Linux Terminal
2. Make the Linux Terminal Full Screen
3. Type in the mode to run and follow the instructions